Programming Channels Into The Tv's Channel Memory; Programming Channels Automatically; Manually Adding And Deleting Channels In The Channel Memory - Toshiba 26AV502RY Owner's Manual

Programming channels into the
TV's channel memory
When you press or
control panel, your TV will stop only on the channels
you programmed into the TV's channel memory.
Follow the steps below to program channels into the
TV's channel memory.

Programming channels automatically

Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Note:
• You must configure the ANT/CABLE input
source before programming channels (
page 29).
• The automatic channel programming process
will erase channels that were previously
programmed into the TV's memory.
• To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
• Programming channels when the ANT/
CABLE input is configured for Cable will take
substantially longer than when the antenna
input is configured for Antenna. This is
normal; however, once channel programming
is finished, you should not have to repeat
the programming process again unless your
Cable TV service lineup changes significantly.
To program channels automatically:
1無
Configure the antenna input source, if you have
not already done so ( page 29).
2無
and open the Setup menu.
Press
3無
Highlight Installation and press
4無
(A new set of Installation menu icons will
appear, as shown next.) Open the Terrestrial
30
Chapter 5: Setting up your TV
on the remote control or TV
.
menu, highlight Channel Program to bring up
the Start, and press
programming.
The TV will automatically cycle through all the
antenna channels, and store all active channels
in the channel memory. While the TV is cycling
through the channels, the message "Scanning
channels, please wait" appears (as shown above).
5無
To cancel channel programming, press
the remote control (or highlight Cancel in the on-
screen display and press
When channel programming is finished, press
or to view the programmed channels.
Manually adding and deleting
channels in the channel memory
After automatically programming channels into the
channel memory, you can manually add or delete
individual channels.
To add or delete channels in the channel
memory:
1無
From the Setup menu, highlight Installation and
. A new set of Installation menu icons
press
will appear.
2無
Open the Terrestrial menu, highlight Channel
Add/Delete, and then press
To add a channel to the channel memory:
Highlight the unchecked box next to the channel
number you want to add, and then press
the box.
again to begin channel
on
).
.
to check
(continued)