Micro-Sd Card Insertion & Termination - Eneo 213541 Quick Installation Manual

Micro-SD Card Insertion & Termination
The device which is connected at end of line, whether it is a dome camera or keyboard
controller, must have the cable for communication terminated by setting the appropriate
DIP switch. Without proper termination, there is potential for control signal errors. Total
length of the cable for communication should not exceed 1.2 km.
User can install and change Micro-SD card as shown in the following picture.
Open the cover.
To detach PTZ module from
external housing, please turn it
counterclockwise.
Remove the screw.
Micro-SD Card Slot
Install or change Micro-SD card.
EN
Reset button
RS485 termination
switch
11