Kyocera Ecosys P3260dn Operation Manual page 230

Troubleshooting > Troubleshooting
Symptom
Printouts are wrinkled.
Printouts are curled.
Printer driver cannot be
installed.
Cannot print.
Cannot print with USB drive.
USB drive not recognized.
While [Auto-IP] is already
set to [On], the IP address is
not assigned automatically.
The machine is emitting
steam in the area around the
paper ejection slot.
Checkpoints
Is the paper loaded correctly?
―
Is the paper damp?
―
Is the paper damp?
Is the driver installed with the host name
while Wi-Fi or Wi-Fi Direct function is
available?
Is the machine plugged in?
Is the machine powered on?
Are the USB cable and network cable
connected?
Is the USB host blocked?
―
Is a value other than "0.0.0.0" entered
for the link local address of TCP/IP(v4)?
Check the room temperature to see if it
is low, or if damp paper was used.
Corrective Actions
Load the paper correctly.
Turn the orientation 180 degrees around
in which the paper is positioned.
Replace the paper with new paper.
Turn the paper over in the cassette, or
turn the orientation 180 degrees around
in which the paper is positioned.
Replace the paper with new paper.
Specify the IP address instead of the
host name.
Plug the power cord into an AC outlet.
Turn on the power switch.
Connect the correct USB cable and
network cable securely.
Select [Unblock] in the USB host
settings.
Check that the USB drive is securely
plugged into the machine.
Enter "0.0.0.0" for the IP address of
TCP/IP(v4).
Depending on the printing environment
and the paper's condition, the heat
generated during printing will cause the
moisture in the paper to evaporate, and
the steam emitted may look like smoke.
This is not a problem, and you can
continue printing. If the steam concerns
you, raise the room temperature, or
replace the paper with a newer, dryer
paper.
10-12
Reference
Page
page 3-2
page 3-2
page 3-2
page 3-2
page 3-2
―
―
page 2-9
page 2-8
page 8-36
―
page 2-16
―