M-system R7L-YV2 Instruction Manual page 16

■ FUNCTIONAL BLOCK: fbDIEX[0...7]
• Network Variables
Normal Mode
TYPE
NETWORK
{ Range }
VARIABLE
{ Default }
{SNVT_switch}
nvoDIEX1 {0.0 0}, {100.0 1}, {Invalid}
{0.0 0}
{SNVT_switch}
nvoDIEX2 {0.0 0}, {100.0 1}, {Invalid}
{0.0 0}
Combination Mode
TYPE
NETWORK
{ Range }
VARIABLE
{ Default }
{SNVT_switch}
nvoDIEX1 {0.0 0}, {100.0 1}, {Invalid}
{0.0 0}
{SNVT_switch}
nvoDIEX2 {0.0 0}, {100.0 1}, {Invalid}
{0.0 0}
• Configuration Properties
CONFIGURATION NETWORK
PROPERTY VARIABLE
SCPTdirection ----
SCPTinvrtOut nvoDIEX1
SCPTinvrtOut nvoDIEX2
EXPLANATIONS
Outputs X0, X2, X4, X6, X8, XA, XC, XE status of the extension module
Outputs X1, X3, X5, X7, X9, XB, XD, XF status of the extension module
EXPLANATIONS
TYPE
{ Range }
{ Default }
{SNVT_state}
{0 or 1}
{0,0,0,0,0,0,0,0,
0,0,0,0,0,0,0,0}
{SNVT_lev_disc}
{ST_OFF, ST_ON}
{ST_OFF}
{SNVT_lev_disc}
{ST_OFF, ST_ON}
{ST_OFF}
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
Contact input, nvoDIEX1 and nvoDIEX2 Reference Table
X0 X1
X2 X3
X4 X5
X6 X7
X8 X9
XA XB
XC XD
XE XF
OFF OFF
ON OFF 100.0 1 (ON)
OFF ON
ON ON 100.0 1 (ON)
EXPLANATIONS
Bit 0, Bit 1: fbDIEX operating mode
0,0 : Normal mode
0,1 : Combination mode
Bit 2 through 15 : Invalid
Contact input logic is inverted at nvoDIEX1.
ST_OFF : OFF at open contact, ON at closed contact
ST_ON : ON at open contact, OFF at closed contact
Contact input logic is inverted at nvoDIEX2.
ST_OFF : OFF at open contact, ON at closed contact
ST_ON : ON at open contact, OFF at closed contact
R7L-YV2
nvoDIEX1 nvoDIEX2
0.0 0 (OFF) Invalid
Invalid
0.0 0 (OFF) 0.0 0 (OFF)
100.0 1 (ON)
EM-7804-D Rev.5 P. 16 / 16