LG VSR8600 Manual page 21

CLEANING MODES
My Space Cleaning
Pressing 'My Space' on the Remote Controller will set the My Space
cleaning mode with a voice message.
For cleaning of particular spaces, select this mode.
The 1st stage:
Use the Remote Controller to manually set the parameters of each
cleaning block.
※ This cleaning mode will be accepted when the distance of the start and
end position is less than 1 m in area.
The 2nd stage:
Pressing the ' ' button will then make the Robot Cleaner clean the manually outlined area by itself.
※ Upon failure to correctly outline a zone, a voice will announce, which says "Area does not meet the
specified conditions. Please continue to make specified area for cleaning process."
Use the Remote Controller to assign a zone, again.
※ Upon completion of cleaning for all selected areas, the Robot Cleaner will resume the cleaning
mode (Zigzag or Cell by Cell) which it was last set to.
Tip
• While recharging, you cannot activate 'My Space' mode.
• To change the cleaning mode while the Robot Cleaner is in operation, press
first then select a cleaning mode. The cleaning will then start from the begining.
20
My Space
button