Suspended Installation - Omnitronic KPR-210A User Manual

Before attaching the speaker-system, make sure that the installation area can hold a minimum point load of
10 times the installation's weight (e.g. 13 kg weight – 130 kg point load).
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
The wall-mounting must always be installed via all fixation holes. Do only use appropriate screws and make
sure that the screws are properly connected with the ground.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Procedure:
Step 1: On the wall-mounting, there are 4 holes for the installation.
Step 2: Hold the wall-mounting onto the location where it is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the wall-mounting in the desired position and tighten the screws.
Step 6: Insert the eye-bolt into one of the threaded holes. Turn the eye-bolt till stop position.
Step 7: Install the speaker-system on the wall-mounting.
Step 8: Install the safety-rope in the wall-mounting's safety eyelet and pull it through the eye-bolt at the
speaker-system.
The wall mounting's maximum service life must never be exceeded.

Suspended installation

This speaker-system must never be suspended – Danger to Life due to crashing
speaker-systems!
The speaker-system must always be secured via an appropriate
eye-bolt.
Appropriate eye-bolts:
Eye-bolt M8 No. 30001165
30/32 11038692_V_1_1