Suspended Installation - Omnitronic AZ-208 User Manual

When installed on a wall-mounting, the speaker-system must always be secured with a safety bond.
installation.
Step 2: Hold the wall-mounting onto the location where it is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the wall-mounting in the desired position and tighten the screws.
Step 6Install the speaker-system on the wall-mounting.
The wall mounting's maximum service life must never be exceeded.

Suspended installation

This speaker-system must only be suspended by experienced and trained persons - Danger to
Life due to crashing speaker-systems!
Trained persons are e.g. Head Rigger, Lightcrew head etc.
If you lack these qualifications, do not attempt the installation yourself, but instead use a professional
structural rigger.
If you have doubts concerning the safety of a possible installation, do NOT install the speaker-system!
The speaker-system has to be installed out of the reach of people.
The installation material must always hold at least 12 times the weight of the speaker-systems.
Please note:
You must never install one speaker-system under another!
When deinstalling the speaker-system, make sure that you insert the original screws in the threaded holes!
Horizontal suspension:
Please note:
The horizontal installation must always be carried out via three eye-bolts and appropriate chains. The
speaker-system must always be installed absolutely planar (vertical angle 90°, horizontal angle 0°).
Before attaching the speaker-system, make sure that the
installation area can hold a minimum point load of 5 times the
installation's weight (e.g. 20 kg weight – 100 kg point load).
The durability of the installation depends very much on the
material used at the installation area (building material) such as
wood, concrete, gas concrete, brick etc. This is why the fixing
material must be chosen to suit the wall material. Always ask a
specialist for the correct plug/screw combination indicating the
maximum load and the building material.
The wall-mounting must always be installed via all fixation holes.
Do only use appropriate screws and make sure that the screws
are properly connected with the ground.
Procedure:
Step 1: On the wall-mounting, there are 4 holes for the
DANGER!
31/40 00033195.DOC, Version 1.2