Suspended Installation; Operation - Omnitronic KPA-206 User Manual

When installed on a wall-mounting, the speaker-system must always be secured with a safety-rope.
Procedure:
Step 1: On the wall-mounting, there are 4 holes for the installation.
Step 2: Hold the wall-mounting onto the location where it is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the wall-mounting in the desired position and tighten the screws.
Step 6: Insert the eye-bolt into one of the threaded holes. Turn the eye-bolt till stop position.
Step 7: Install the speaker-system on the wall-mounting.
Step 8: Install the safety-rope in the wall-mounting's safety eyelet and pull it throught the eye-bolt at the
speaker-system.
The wall mounting's maximum service life must never be exceeded.

Suspended installation

This speaker-system must never be suspended - Danger to Life due to crashing
speaker-systems!

OPERATION

After having connected your amplifier to the mains, turn both gain controls counter-clockwise to Min-position.
The last device to be switched on is the amplifier. The "ON" and "PROTECT" LED light up now. If it does not,
check if the amplifier is connected to the mains correctly.
After the turn-on delay the speakers are activated (PROTECT-LED is off).
After having set the volume controls of the pre-amplifier in null-position, turn the gain controls of your
amplifier to mid-position. You must not hear any loud humming. If there is humming nevertheless, check the
Before attaching the speaker-system, make sure that the
installation area can hold a minimum point load of 10 times the
installation's weight (e.g. 13 kg weight - 130 kg point load).
The durability of the installation depends very much on the material
used at the installation area (building material) such as wood,
concrete, gas concrete, brick etc. This is why the fixing material
must be chosen to suit the wall material. Always ask a specialist for
the correct plug/screw combination indicating the maximum load
and the building material.
The wall-mounting must always be installed via all fixation holes.
Do only use appropriate screws and make sure that the screws are
properly connected with the ground.
A safety rope which already hold the strain of a crash or which is
defective must not be used again.
The speaker-system must always be secured via an appropriate
eye-bolt.
Appropriate eye-bolts:
Eye-bolt M10 No. 30001166
30/36 KPA_SERIES.DOC