Related Manuals for HIKVISION DS-2CD7A26G0/P-LZHS
Summary of Contents for HIKVISION DS-2CD7A26G0/P-LZHS
- Page 1 Bullet Network Camera Quick Start Guide COPYRIGHT © 2018 Hikvision. ALL RIGHTS RESERVED...
-
Page 2: All Rights Reserved
This user manual (hereinafter referred to be “the Manual”) cannot be reproduced, changed, translated, or distributed, partially or whol- ly, by any means, without the prior written permission of Hikvision. Unless otherwise stipulated, Hikvision does not make any warran- ties, guarantees or representations, express or implied, regarding to the Manual. - Page 3 LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA OR DOCUMENTATION, IN CONNECTION WITH THE USE OF THIS PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. REGARDING TO THE PRODUCT WITH INTERNET ACCESS, THE USE OF PRODUCT SHALL BE WHOLLY AT YOUR OWN RISKS.
- Page 4 —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help FCC conditions This device complies with part 15 of the FCC Rules. Operation is sub- ject to the following two conditions: 1.
-
Page 5: Safety Instruction
Safety Instruction These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss. Laws and Regulations The device should be used in compliance with local laws, electrical safety regulations, and fire prevention regulations. Transportation Keep the device in original or similar packaging while transporting it. -
Page 6: Using Environment
A few device components (e.g., electrolytic capacitor) require regular replacement. The average lifespan varies, so periodic checking is recommended. Contact your dealer for details. Cleaning Please use a soft and dry cloth when clean inside and outside surfaces of the product cover. Do not use alkaline detergents. -
Page 7: Installation
Set up camera time manually for the first time access if the local time is not synchronized with that of the network. Visit the camera via Web browse/client software and go to time settings interface. White Light Illuminator (If supported) The white suppliment light source of the camera is classified as Risk Group 2 (RG2). -
Page 8: Symbols And Marks
Make sure that the power has been disconnected before you wire, install, or disassemble the device. Make sure that no reflective surface is too close to the camera lens. The IR light from the camera may reflect back into the lens causing reflection. Symbols and Marks Notice Warning... - Page 9 Disposal Purchase separately Other situations Other situations omitted Waterproof Skip this step if not necessary Statement (for product with white light illuminator) The product should be positioned so that prolonged staring into its white light source at a distance closer than 3 m is not expected.
- Page 10 1x *...
- Page 11 1.1 * microSD...
- Page 13 A.1-A.5 B.1-B.5...
- Page 15 5.5mm Ø 24mm Ø...
- Page 18 5.5mm Ø...
- Page 28 0°-355° 0°-90° 0°-360°...
- Page 31 4.1 * For anti-corrosion models, you must apply anti-corrosion gel to the screws that are exposed to corrosive atmosphere.
- Page 33 Activate and Access Network Camera Scan the QR code to get Activate and Access Camera. Note that mobile data charges may apply if Wi-Fi is unavailable.
- Page 34 UD10596B-A...
Need help?
Do you have a question about the DS-2CD7A26G0/P-LZHS and is the answer not in the manual?
Questions and answers