Table of Contents
Advertisement
7.3. Using as a Floor Monitor
Notes
• When installing the speaker system on slippery floor,
put a non-slip mat under the speaker.
• Do not kick or stand on the speaker system, as this
will damage the speaker.
7.4. Attaching the Supplied Rubber Feet
Attach the rubber feet in the case of speaker storage or
on-floor speaker installation.
Note
The rubber foot has a direction (back and forth).
Align the datum line on the rubber foot with the positioning
mark (
) on the speaker unit as shown at right.
7.5. Attaching a Handle
The speaker system comes with a handy carrying handle.
Attach the handle on the speaker's top surface.
8. EQUALIZING BY THE DIGITAL SIGNAL PROCESSOR
The speaker system is capable of providing high-efficiency and wide range reproduction without using an
equalizer, however more clear and dynamic sound quality can be reproduced by using our digital signal
processor and performing its settings as shown in the tables below.
[For the HS-120B and HS-120W]
Filter
Frequency (Hz) Gain (dB)
HPF (12 dB)
PEQ
PEQ
1500
PEQ
3000
PEQ
5000
PEQ
14000
50
580
-5.0
-5.0
-5.0
-2.0
+2.0
The figure shows the HS-120 series.
Rubber foot
(accessory)
[For the HS-150B and HS-150W]
Q
Filter
1.618
HPF (12 dB)
3.134
PEQ
2.016
PEQ
2.016
PEQ
1.414
PEQ
0.718
PEQ
Datum line
Positioning mark
Screw M6 x 30 (accessory)
Screw M6 x 30
(accessory)
Handle fitting bracket
(accessory)
Handle
(accessory)
Frequency (Hz) Gain (dB)
50
500
-4.5
1250
-3.0
2900
-5.0
6500
-3.0
14000
+3.0
Q
1.450
1.850
3.450
1.850
1.414
0.776
7
Advertisement
Table of Contents
