VIA Mainboard 845G Series Manual page 17

Hardware Installation
2.4.6. WOL (Wake-On-LAN) Connector
Connector: CN16
Type:
3 pin
The mainboard has a WOL (Wake-On-LAN) connector. This connector must be
connected to a LAN card that has Wake-On-LAN (WOL) output. It powers up
the system when a wakeup packet or signal is received through the LAN card.
In order to use the WOL LAN card to trigger the power on the PC system, the
switching power supply must have the ability to provide a driving current of at
least 720 mA and be connected to a "5V standby" voltage.
Top View of a WOL Connector
1 5V_SB
2 Ground
3 WOL
2.4.7. CD-IN/AUX-IN Connector
Connector: CN21 (CD-IN)/CN45 (AUX-IN)
Type: 4 pin un-housed
This mainboard has one CD-IN connector, AUX-IN connector. The CD-IN con-
nector is used to connect the CD ROM audio out and allows the system to re-
ceive audio input from the CD ROM. The AUX-IN connector allows the system
to receive signals from other audio devices like a radio or tape.
Top View of a CD/AUX-IN
Connector
1 Left Channel CD/AUX-IN
2 Ground
3 Ground
4 Right Channel CD/AUX-IN
2.4.8. SCR Connector iTE type (optional)
Connector:
CN41
Type: 14 pin
The smart card PCB is connected to the motherboard with a 14-pin ribbon ca-
ble. Please make sure the Pin 1 location.
The 845G MAINBOARD Series
Front View of a WOL Connector
Ground
5V_SB
Front View of a CD/AUX-IN
Connector
Left Channel
CD-IN/
AUX-IN
Ground


WOL
Right Channel
CD-IN/
AUX-IN
Ground
Page 17