Page 2
The Denby Towel Rack is intended for towel warming/drying, auxiliary heating or as a decorative product. The average heat up time is about thirty minutes, but would depend on a ) the size of the unit and b ) the initial temperature of the unit. Typically the unit is programmed to be on an hour before expected use and remain on for an hour afterwards.
Page 3
TECHNICAL SPECIFCATIONS MODEL# M17260 ELECTRIC VERSION Element specifications 200W, 110V, 48” cord, UL approved. Hardwire Kit CSA-US approved. File ref: 229718 HYDRONIC VERSION Heat ouput 4433 BTU. ½” BSPT tappings. Steel towel warmers should only be used in a closed water system, incorporating a rust inhibitor.
Page 4
INSTALLATION STEPS 1. Check that all the installation pack contents have been received. There should be 1 item as shown below plus the towel warmer: B r a c k e t s 2. 2. 2. 2. Determine location of towel warmer near a electrical outlet. The towel warmer cord is 4 ’ long.
Page 5
INSTALLATION STEPS 5. Determine location of #6 outer rear cylinder by measuring the brackets attached to towel warmer. Attach #6 cylinder to wall with hole for #7 locking screw facing down on the bot- tom brackets and facing up on the top brackets. 6.
Page 6
Under the warranty we will provide replacement components or product at our discretion. Westover, Inc is not responsible for labor charges connected with removal or installation. PLEASE REGISTER THIS PRODUCT ONLINE AT WWW.ARTOS- - - - WESTOVER.COM PLEASE REGISTER THIS PRODUCT ONLINE AT WWW.ARTOS WESTOVER.COM...
Need help?
Do you have a question about the Denby M17260P and is the answer not in the manual?
Questions and answers