Satellite Button - Novra S300V User Manual

1. Obtain an IP Address Automatically: This checkbox will force the S300 to use DHCP to
automatically obtain its IP address.
2. Receiver IP: This is the IP address that is statically assigned to the receiver.
3. Subnet Mask: This is the subnet mask that the receiver should use to determine whether an IP
address belongs to the same network or not.
4. Default Gateway: This is the IP address of the router that the receiver should use whenever it
wants to send traffic to a non-local address.
5. Enable IGMP Filtering: This check box allows the operator to turn IGMP filtering on or off. IGMP
controls which multicast streams will be forwarded on the LAN based on the number of clients
listening to that stream.
NOTE:
network support IGMP protocol.
6. Command Port: This is the UDP port that is used by the S300 status messages
7. Apply: By pressing this button, the updates are sent to the receiver
8. Exit: Exits back to the main screen

4.1.2 Satellite Button

The next step in the configuration is to ensure you have the correct RF settings and that the S300 can
successfully lock to your satellite signal. To configure your satellite settings, select the Satellite
configuration button (see
Version: 2.02
-
Proper operation of IGMP protocol requires that all devices used in the
7
below) and input the following fields:
Confidential and Proprietary 18 of 50