Novra S300V User Manual page 37

5. Exit: Exits the S300 Console program
6. Change Firmware: Allows the user to download a new firmware load for the S300 receiver.
To change the S300 firmware, please refer to the Figure below:
a. Select Code File and browse to the S300 code update binary file.
i. The firmware update function is ONLY applicable for S300 DSP firmware files and
ii. The DSP file will be a binary file (eg: S300VS2_V1R3M18.bin)
iii. The CAM controller firmware file will have a ".cam" suffix (eg: CAM_V6R4.cam). The
b. Select Commit.
c. On the firmware upload is complete you should get a message stating the Receiver
firmware has been rewritten. The S300 Console program will then shut down and must
be restarted to continue configuring the S300.
d. If you get a Code Download Failed timeout error, ensure your have changed your IP
addresses per the note above.
Version: 2.02
Figure 16 - Change Password
the S300 CAM controller firmware files.
CAM controller firmware upgrade is only applicable to the S300CA receivers
Confidential and Proprietary 37 of 50