Novra S300V User Manual page 20

4) ModCod: For multi-stream DVB-S2 operation, the S300 should be configured to receive 1 stream.
This is accomplished by entering the ModCod of the signal you wish to receive in the ModCod drop
down box. If you enter the wrong ModCod value, you receiver may not be able to lock onto the
desires signal.
For single stream DVB-S2 operation, the Modcod dropdown should be set to All.
For DVB-S operation, the Modcod box will be grayed out.
NOTE:
then the contents of the ModCod box will be ignored by the receiver.
5) LNB Power On: Turns the DC voltage and tone output of the receiver to ON or OFF.
a. Polarization: Switches the DC output of the receiver between Horizontal/Left and
Vertical/Right. This setting is only valid if the LNB power is on.
NOTE:
button.
b. Band (Tone): Switch the LNB Tone frequency of the receiver On (High) or Off (Low). This
is only valid if the LNB power is on.
NOTE:
button.
.
Version: 2.02
-
If the Search Mode is set to Both and the received stream is DVB-S,
-
The LNB voltage level may be set by selecting the LNB Parameters
-
The LNB tone frequency may be set by selecting the LNB Parameters
Confidential and Proprietary 20 of 50