Table of Contents
Advertisement
Installation
Bend the claws
according to
the thickness
of the
dashboard
Control panel
A
A
4
3
5
6
Connection diagram
Connecting to Auxiliary equipment
(Optional)
Connect the AUDIO OUTPUT jack of this unit
to the AUDIO INPUT jack of the Auxiliary
Equipment.
Basic Installation
Before installing, make sure that the ignition-switch is set to
OFF and remove the terminal of the car battery to avoid
short-circuiting.
1 Remove the existing receiver unit.
2 Make the necessary connections.
3 Install the installation sleeve.
4 Install the unit into the installation sleeve.
Removing the existing receiver unit
If there is already an installation sleeve for the receiver unit in
the dashboard, it must be removed.
1 Remove the rear support from the unit.
2 Remove the control panel and trim ring from the unit.
3 Insert the lever A into the hole on one side of the unit.
Perform the same operation on the other side and pull the
unit out from the mounting sleeve.
ISO-DIN Installation
1 Slide the unit into the ISO-DIN frame.
2 Fit screws removed from the old unit.
3 Slide the unit and frame into the dash opening.
1
4 Install the dash panel or adapter plate.
5 Install the trim ring to the unit.
2
6 Install the control panel to the unit.
Amplifier
9
RL ( Rear Left)
SL (Subwoofer L)
SR (Subwoofer R)
RR ( Rear Right)
To AUDIO OUT
To AUDIO IN
Subwoofer Amplifier
To AUDIO IN
Advertisement
Table of Contents
