Table of Contents
Advertisement
4.
Place the bracket in position, after first passing the line and the loudspeaker
cable through the square hole on the bracket. Fix the bracket to the wall.
Connect the loudspeaker cable to the connector on the rear part of the box,
using the Euroblock connector supplied. Ensure the correct polarity of the
terminals and that the cable goes through the square hole in the bracket. It is
advisable to place the protective housing supplied when the loudspeaker is
installed outdoors.
5.
Place the acoustic box in its final position, vertically sliding it downward so
that the rail on its rear side fits with the bracket rail. Fasten the safety cable
on the rear part of the acoustic box, to avoid it accidentally falling and
causing material and/or personal damage.
6.
Orientate the box to obtain the required position on the vertical and
horizontal axes. Tighten the Allen screws on the bracket to fix said position
on both axes.
7. Adjust the power selector to the required position.
6
Advertisement
Table of Contents
