TRENDnet TI-G102i User Manual page 106

TRENDnet User's Guide
if-range dhcp-snooping host
if-range no dhcp-snooping host
if-range dhcp-snooping trust
if-range no dhcp-snooping trust
Example:
[DEVICE_NAME]#configure terminal
[DEVICE_NAME](config)#dhcp-snooping enable
[DEVICE_NAME](config)#dhcp-snooping vlan 1
[DEVICE_NAME](config)#interface 1/0/1
[DEVICE_NAME](config-if)#dhcp-snooping trust
Web Configuration
DHCP Snooping
Security > IP Source Guard > DHCP Snooping > DHCP Snooping
© Copyright 2018 TRENDnet. All Rights Reserved.
This command configures the
maximum host count for the
specific ports.
This command configures the
maximum host count to default for
the specific ports.
This command configures the trust
port for the specific ports.
This command configures the un-
trust port for the specific ports.
Parameter Description
Select Enable to use DHCP snooping on the Switch. You still
have to enable DHCP snooping on specific VLANs and specify
trusted ports.
State
Note: The Switch will drop all DHCP requests if you enable
DHCP snooping and there are no trusted ports.
Select Disable to not use DHCP snooping.
Select Add and enter the VLAN IDs you want the Switch to
enable DHCP snooping on. You can designate multiple VLANs
individually by using a comma (,) and by range with a hyphen (-
VLAN State
).
Select Delete and enter the VLAN IDs you no longer want the
Switch to use DHCP snooping on.
Apply Click Apply to take effect the settings.
Refresh Click Refresh to begin configuring this screen afresh.
DHCP Snooping Status
DHCP Snooping
This field displays the current status of the DHCP snooping
feature, Enabled or Disabled.
State
This field displays the VLAN IDs that have DHCP snooping
Enabled on VLAN enabled on them. This will display None if no VLANs have been
set.
Managed Industrial L2 Switch
103