Troubleshooting; Warranty - GEHA Home & Office X6CD Manual

TROUBLESHOOTING

Index Malfunction
After having completed the
regular shredding process,
the machine does not stop
1
running.
Paper feed or sense of rotati-
on is normal, but there is still
2
some waste paper hanging at
the exit.
The machine stops, when
3
pulled in paper collides with
exited paper.
The machine does not start
although paper is in the entry.
4
The paper is jammed, and the
machine stops rotating.
5
The machine does not start
after inserting a sheet of pa-
6
per or it stops running when
paper is being inserted.
DISPOSAL
The symbol depicting a crossed-out rubbish bin means that electrical devices
may not be disposed with regular household waste. Please bring the device to
an approved recycling centre for environmentally friendly disposal.

WARRANTY

The warranty period for your device is 24 months.
Make sure to keep both your proof of purchase and the original packaging.
Please contact your retailer in case of any problems with the device.
Cause
There is too much shredded
paper in the waste basket.
The shredded paper cannot
fall into the waste basket and
clear the feed.
Shredded paper is blocking
the paper feed slot.
Shredded paper is blocking
the automatic induction
sensor.
The paper feed takes the cor-
ners of the paper in, however,
the remaining area of the
paper is not sensed auto-
matic induction sensor.
1. The maximum paper
feed-in capacity has been
exceeded.
2. The motor has overheated
due to a blocked ventilator,
which has resulted in the ac-
tivation of the heat protection
system.
The paper is too thin, too soft,
moist or too crinkly to acti-
vate the automatic induction
sensor.
Countermeasure
1. Turn off the power, and
empty the waste basket.
2. Turn off the power, and
press the waste paper down
to clear the entry.
Set the slide switch to „REV"
(if necessary, please remove
the shredded paper at the
exit of the feed).
Set the slide switch to „REV".
Adapt the position of the
feeding paper and make it
touch the automatic induction
sensor.
1. Set the sliding switch to
„REV" and withdraw the
shredding paper.
2.Unplug the plug and allow
the machine to cool down for
a while.
1. Fold the paper and then
insert it.
2. Set the slide switch to
„REV".
GB
11