Table of Contents
Advertisement
AXIS Q35 Network Camera Series
Additional settings
9. Click Save.
Detect tampering with input signal
This example explains how to trigger an alarm when the input signal has been cut or short-circuited. For more information about the
I/O connector, see page 23.
1. Go to Settings > System > I/O Ports and turn on Supervised I/O for one of the ports.
Create a rule:
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, select Digital input and then select a port.
4. In the list of actions, select Send notification to email and then select a recipient from the list. Go to Recipients
to create a new recipient.
To create a new recipient, click
5. Type a subject and a message for the email.
6. Click Save.
Record video when the camera detects impact
Shock detection allows the camera to detect tampering caused by vibrations or shock. Vibrations due to the environment or to an
object can trigger an action depending on the shock sensitivity range, which can be set from 0 to 100. In this scenario, someone is
throwing rocks at the camera after hours and you would like to get a video clip of the event.
Turn on shock detection:
1. Go to Settings > System > Detectors.
2. Turn on shock detection, and set a value for the shock sensitivity.
Create a rule:
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under Device status, select Shock detected.
4. Click + to add a second condition.
5. In the list of conditions, under Scheduled and recurring, select Scheduled event.
6. In the list of schedules, selet After hours .
7. In the list of actions, under Recordings, select Record video while the rule is active.
8. Select a Camera.
9. Set the prebuffer time to 5 seconds.
10. Set the postbuffer time to 60 seconds.
11. Select where to save the recordings.
12. Click Save.
. To copy an existing recipient, click
17
.
Advertisement
Table of Contents
