Using The Accessories - AEG BPK556220W User Manual

12 www.aeg.com
temperature right or left to set the
hours for DURATION time and press
to confirm.
The display shows flashing
4. Turn the knob for the temperature
right or left to set the hours for END
time and press
the knob for the temperature right or
left to set the minutes for END time
and press
Oven turns on automatically later on,
works for the set DURATION time and
stops at the set END time.
At the set END time the signal sounds
for 2 minutes.
in the display. The oven turns off.
5. Press any button or open the oven
door to stop the signal.
6. Turn the knob for the oven functions
to the off position.
7.6 Setting the MINUTE
MINDER
Minute minder can be both set when the
oven is turned on and off.

8. USING THE ACCESSORIES

WARNING!
Refer to Safety chapters.
8.1 Core temperature sensor
The core temperature sensor measures
temperature inside the food. When the
food is at the set temperature, the oven
turns off.
There are two temperatures to be set:
• the oven temperature (minimum 120
°C),
• the food core temperature.
CAUTION!
Use only the core
temperature sensor supplied
and the original replacement
parts.
Directions for the best results:
• Ingredients should be at room
temperature.
.
to confirm. Turn
to confirm.
and time setting flash
1. Press .
and "00" flash in the display.
2. Turn the knob for the temperature
right or left to set the seconds and
than the minutes.
When the time you set is longer than
60 minutes,
3. Set the hours.
4. The MINUTE MINDER starts
automatically after 5 seconds.
After 90% of the set time the signal
sounds.
5. When the set time ends the signal
sounds for 2 minutes. "00:00" and
flash in the display. Press any
button to stop the signal.
• Core temperature sensor cannot be
used for liquid dishes.
• During cooking the core temperature
sensor must remain in the dish and
the plug in the socket.
• Use recommended food core
temperature settings. Refer to "Hints
and tips" chapter.
Every time you put the core
temperature sensor in the
socket, you need to set the
core temperature time
again. You cannot select the
duration and end time.
The aoven calculates the
approximate cooking time, it
may change.
flash in the display.