BTC Emprex 6311ARF III Quick Installation Manual

Wireless Keyboard /
Quick Installation Guide (English)
1. Make sure the batteries of the keyboard is installed correctly. Please follow the polarity
signs in the battery compartment.
2. Please make sure the slide switch on the back of the Keyboard is switched to "on"
before using the ketboard. When not in use, please turn the power switch to "off" for
power saving.
3. Plug the receiver directly into your available USB port on PC.

Change the cursor pointer speed

You can modify the mouse pointer speed settings in the control panel.
1. Open the Start Menu by clicking "Start" at the lower-left corner on the screen
2. Then click on Settings / Control Panel / keyboard
3. In the Keyboard Properties window that appears, click the Motion tab
4. Move the slide bar toward either the faster end or the slower end
5. Click OK to exit and make the change effective

Pairing Procedure

It can operate out of the box immediately after you plug the receiver USB connector into
your PC USB port. If it can't work, please visit our website to download and install the
"Pairing Tool."

System Requirements

Available USB port
Microsoft® Internet Explorer 6.0 or later version (for the Internet keys)
Microsoft® Windows® 7, Windows® XP or Windows Vista® operating system
The system supports ACPI or APM II (for power management buttons)
ATX mother board and ATX power supply (for power management buttons)
EMPREX,BTC
6311ARF III /
Requisiti del sistema