Advertisement
USING AS-8510/8512 RADIO CRADLE
The AS-8510/8512 radio cradle paired with one
AS-8510/8512 scanner, builds a Cordless Reading
System for the collection, decoding and transmission
of barcoded data.
It can be connected to a Host PC through an RS232,
Keyboard wedge or USB cable and is suited for a
single-cradle layout.
The LEDs signal of the AS-8510/8512 radio cradle
status, as described in the following:
BATTERY:
-
Green LED blinking: the batter charge is in
progress.
-
Green LED On: the battery is completely charged.
TRANSMISSION:
-
Green LED On: the radio cradle is powered.
-
Orange LED blinking: the radio cradle receives
data and commands from the Host or the
scanner.
CONNECTING AND DISCONNECTING
THE RADIO CARDLE INTERFACE
CABLE
The radio cradle can be connected to a Host by
means of an RS232, Keyboard wedge or USB cable
which must be simply plugged into the Host connector,
placed on the base of the cradle. In addition the cradle
must be connected to an external power supply.
To disconnect the cable, insert a paper clip or other
small similar object into the hole at the back of the
cradle. Push down on the clip while unplugging the
cradle.
1
Advertisement
