Table of Contents
Advertisement
Available languages
Available languages
4.
Switch on the motor only when the hands and
feet are away from the cutting tool.
5.
Before starting make sure that the cutting tool has
no contact with any objects.
Method of operation
1.
Only use the equipment in good light and visibility.
During the winter season beware of slippery or
wet areas, ice and snow (risk of slipping). Always
ensure a safe footing.
2.
Take care against injury to feet and hands from
the cutting tool.
3.
Never stand on a ladder and run the equipment.
4.
Never climb up into trees to perform cutting
operation with the equipment.
5.
Never work on unstable surfaces.
6.
Remove sand, stones, nails etc. found within the
working range. Foreign particles may damage the
cutting tool and can cause dangerous kick-backs.
7.
Should the cutting tool hit stones or other hard
objects, immediately switch off the motor and
inspect the cutting tool.
8.
Inspect the cutting tool at short regular intervals
for damage (detection of hairline cracks by
means of tapping-noise test).
9.
Before commencing cutting, the cutting tool must
have reached full working speed.
10. The cutting tool has to be equipped with the
appropriate guard. Never run the equipment with
damaged guards or without guards in place!
11.
All protective installations and guards supplied
with the equipment must be used during
operation.
12. Always remove the battery cartridge from the
equipment:
−
whenever leaving the equipment unattended;
−
before clearing a blockage;
−
before checking, cleaning or working on the
equipment;
−
after striking a foreign object;
−
whenever the equipment starts vibrating
abnormally.
13. Always ensure that the ventilation openings are
kept clear of debris.
Cutting Tools
1.
Employ only the correct cutting tool for the job in
hand.
Maintenance instructions
1.
The condition of the equipment, in particular of
the cutting tool of the protective devices must be
checked before commencing work.
2.
Turn off the motor and remove the battery
cartridge
before
replacing cutting tools or cleaning the equipment
carrying
out
maintenance,
or cutting tool.
3.
Check loose fasteners and damaged parts such
as cracks in the cutting attachment.
4.
Follow instructions for lubricating and changing
accessories.
5.
When not in use, store the equipment indoors in
dry and high or locked-up place - out of the reach
of children. Clean and maintain before storage.
6.
Use only the manufacturer's recommended
replacement parts and accessories.
7.
Inspect and maintain the equipment regularly,
especially before/after use. Have the equipment
repaired only by our authorized service center.
8.
Keep handles dry, clean and free from oil and
grease.
KEEP FOR FUTURE
REFERENCE
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
WARNING:
Use of this product can create dust containing
chemicals which may cause respiratory or other
illnesses.
Some examples of these chemicals are compounds
found
in
pesticides,
herbicides.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter
out microscopic particles.
Symbols
The followings show the symbols used for tool.
･
volts
･
direct current
･
no load speed
･
revolutions or reciprocation per minute
6
insecticides,
fertilizers
USG001-2
and
USD301-1
Advertisement
Table of Contents
