Danby DDW1802EBLS Owner's Use And Care Manual page 11

Features
1. Upper Rack
2. Spray Arms
3. Lower Rack
4. Main Filter
5. Detergent Dispenser
6. Cup Shelf
7. Silverware Basket
8. Coarse Filter
9. Rinse Aid Dispenser
10. Drain Hose
11. Junction Box
12. Leveling Leg
Cleaning:
To clean the control panel, use a lightly dampened cloth then dry thoroughly. To clean the exterior use a cleaner that is
appropriate for cleaning appliances. Never use sharp objects, scouring pads or harsh cleaners on any part of the dish-
washer.
Protect Against Freezing:
If your dishwasher is left in an unheated place during the winter, ask a service technician to:
1. Cut off electrical power to the dishwasher and remove fuses or trip circuit breaker.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the inlet pip and water valve (use a pan to catch the water).
4. Reconnect the water inlet pipe to the water valve.
5. Remove the plastic sump cover in the bottom of the tub and use a sponge to soak up the water in the rubber boot.
Cleaning the Spray Arms:
It is necessary to clean the spray arms regularly, as hard water chemicals will clog the spray arm jets and bearings. To
remove the spray arm, unscrew the nut and take out the washer on top of the spray arm and remove the arm. Wash the
arms in soapy, warm water and use a soft brush to clean the jets. Replace after rinsing them thoroughly.
Cleaning the Filters:
• For best performance and results, the fi lter assembly must be cleaned.
• Inspect the fi lters for obstructions every time the dishwasher has been
used.
• By unscrewing the coarse fi lter, you can remove the fi lter system. Remove
any food remnants and use a cleaning brush to clean the fi lters under
running water.
• Follow Steps 1 to 3 to remove the fi lter system. Follow Steps 3 to 1 to
reinstall the fi lter system.
Warning - Never run the dishwasher without the fi lters in place.
Operating Instructions
Front View
Care and Maintenance
Back View
8
Front View
1
2
3