Manual Mode Setup - Hubsan FPV X4 Desire Instruction Manual

0:08:49
M2
MAIN MENU
Set Reverse
Set Sensitivity
5.8G Frequency
Set Manual
Fly When no GPS
Show Version
Exit
Sensitivity default setting is in Expert Mode.
The quadcopter can't be disarmed when sensitivity value less than "60".

7.5 MANUAL MODE SETUP

If you would like to make acrobatic flights, such as throwing, please switch off the GPS
function and follow the instruction below to enter into the Manual mode
Pull the throttle stick to the lowest position and long press the Elevator stick to enter into the
MAIN MENU interface. Push the Elevator stick up/down to select "Set Manual", push the
stick right to enter into the " SET MANUAL" interface, select "ON" (without altitude function)
or "OFF" (with altitude function).Select" Exit" to exit.
0:08:49
M2
MAIN MENU
Set Reverse
Set Sensitivity
5.8G Frequency
Set Manual
Fly When no GPS
Show Version
Exit
Manual Mode default setting is OFF.
Notice：
1. When the power on the transmitter runs low, the red LED will blink quickly and the LCD
screen will turn black, also the transmitter and X4 may disconnect. Please replace with new
batteries.
2. If the batteries in the transmitter runs low while flying the X4, you can still control the X4,
please land the X4 and then replace batteries.
3. The Transmitter can only use 2S Lipo batteries, 4XAA batteries or NI-MH AA batteries,
other batteries will damage the Transmitter.
15
©2016 Hubsan
哈博森科技 版权所有
0:08:49 M2
SET SENSITIVE
Exit
Expert mode
Elevator :
Aileron :
Rudder :
0:08:49 M2
SET MANUAL
Exit
OFF
100
100
100