Table of Contents
Advertisement
Operation
the choke if it was set closed, and let the
engine run at idle speed for a minute to
warm it up.
NOTE
• When the engine fails to start after several
attempts due to overchoking, open the
choke and repeat pulling the rope.
ADJUSTING IDLE SPEED
• The idling speed is set for 2000 rpm at the
factory. If it is necessary to adjust the idle
speed, use the adjustment screw on the
top side of carburetor.
STOPPING ENGINE
• Move the throttle lever to the idling position
and press the stop switch (red button) until
the engine comes to a complete stop.
Stop Switch
12
Advertisement
Table of Contents
