Electrical Connection - Zanussi ZCOF636X Instruction Book

ELECTRICAL
CONNECTION
• Make sure that the electric circuit is suitably
earthed.
• Connect the power cable supplied to the
connector on the back of the appliance, plug the
connector into the power supply unit on the back
of the post (fig.3) where you will find the
terminal board (fig.9) set to operate at a supply
voltage of 230V monophase.
• Make sure that a circuit breaker is installed in the
electrical circuit of the building to disconnect it
from mains and that contacts are at least 3mm
apart.
• WARNING:
the
responsibility in the case of non-observance of
the above rule.
supplier disclaims all
Fig. 9
16