Table of Contents
Advertisement
Power Indicator
Mode
Power ON
Power OFF and Power Save "AUTO
POWER STANDBY"
Power consumption under 0.5 W
Power Save "AUTO POWER SAVE"
Power consumption under 2.5 W*
2
Power Standby when "SCHEDULE
SETTINGS" enabled
Diagnosis (Detecting failure)
*1 If "OFF" is selected in POWER INDICATOR (page 24), the LED will not light when the
LCD monitor is in active mode.
*2 Without any option, with factory settings.
Initial settings
Setting LAN POWER (see page 26) and POWER SAVE (see
page 25) windows appear on fi rst time the power is on.
These settings are only necessary upon initial setup.
However, this message window appears when the power is
on after FACTORY RESET is done.
When LAN POWER is set to ON and POWER SAVE is set to
"DISABLE" after FACTORY RESET, then the monitor power is
off and on again, the message window will not appear.
Using Power Management
The LCD monitor follows the VESA approved DPM Display
Power Management function.
The power management function is an energy saving
function that automatically reduces the power consumption
of the display when the keyboard or the mouse has not been
used for a fixed period.
The power management feature on your new display has
been set to the "AUTO POWER SAVE" mode. This allows
your display to enter a Power Saving Mode when no signal is
applied. This could potentially increase the life and decrease
the power consumption of the display.
NOTE:
Depending on the PC and video card used, this
function may not operate.
NOTE:
The monitor automatically goes into OFF at the
preset time period after signal is lost.
Status Indicator Light
Green*
1
Red
Amber
Green and Amber blink alternately
Red Blinking
(See Troubleshooting page 44)
English-17
Picture Aspect
DVI, VGA, DPORT
FULL
1:1
ZOOM
NORMAL
HDMI, Y/Pb/Pr, HDMI2
FULL
WIDE
DYNAMIC
Aspect ratio
Unchanged view*
of image
4:3
Squeeze
Letterbox
*
3
Grey areas indicate unused portions of the screen.
NORMAL: Displays the aspect ratio the same as it is sent
from the source.
FULL: Fills entire screen.
WIDE: Expands a 16:9 letter box signal to fill entire screen.
DYNAMIC: Expands a 4:3 pictures to fill the entire screen
with non-linearity. Some of the outside image area will be cut
off due to expansion.
1:1: Displays the image in a 1 by 1 pixel format.
ZOOM
The image can be expanded beyond the active display area.
The image which is outside of active display area is not
shown.
ZOOM
1:1
ZOOM
NORMAL
Recommended selection
3
for picture aspect*
3
NORMAL
DYNAMIC
FULL
WIDE
ZOOM
Advertisement
Table of Contents
