Power On And Off Modes - NEC MultiSync M431 User Manual

Large format display
Table of Contents

Advertisement

Power ON and OFF Modes

Press the ⏻ button on the Control Panel or POWER ON button on the remote control to turn on the monitor.
The monitor's power LED indicates the current status of the monitor. Please refer to the following table for information about the
power indicator.
Power indicator status and
lighting pattern
Glowing blue
1
Blinking green*
Glowing amber
Blinking amber
Glowing red
*
1
: Time setting for auto power save is available at [POWER SAVE SETTINGS] (See
*
2
: [SLOT POWER] is set to [ON] or [AUTO].
*
3
: [MODE] in [POWER SAVE SETTINGS] is set to [NORMAL].

NOTEN:
• The blue power indicator that the monitor is powered on and functioning normally can be turned off in the monitor's
OSD menu options. See
 • If the indicator is blinking red in a combination of long and short durations, a certain failure might have occurred,
please contact your supplier.
The Main Power switch must be in the ON position in order to power up the monitor using the POWER ON button on the remote
control or the ⏻ button on the Control Panel.
OFF
Condition
Normal
Under any of the conditions below, no input
signal has been detected by the monitor during
the period of time you set:
The monitor is using an Option Board*
[AUTO INPUT CHANGE] is set to a setting
except for [NONE].
[USB POWER] is set to [ON].
[SLOT POWER] is set to [ON].
[QUICK START] is set to [ENABLE].
No AV signal input has been detected by the
monitor during the period of time you set.
(with network signal input)
No AV signal input has been detected by the
monitor during the period of time you set.
(no network signal input)
Turn off the monitor by the remote control or the
monitor button.
page
90.
Main Power Switch
ON
1. Turn on the monitor using the remote control
or the monitor button.
2. Send an AV signal input to the monitor.
2
.
1. Turn on the monitor using the remote control
or the monitor button.
2. Send an AV signal input to the monitor.*
3. Disconnect and reconnect a signal cable.
Turn on the monitor using the remote control or
the monitor button.
page
86).
English−34
Recovery
3
⏻ Button

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multisync m491Multisync m551Multisync m651

Table of Contents