Signode TENSION-WELD VT-16HD Operation, Parts And Safety Manual page 15

6. Swing the tool out from the
completed strap joint. Inspect
the joint to make sure the straps
have been properly welded.
STRAP JOINT INSPECTION
This tool is a Tension Weld® type sealer. A properly made joint will appear as shown in the
illustration. If the joint does not appear as shown, then the operator must proceed as
follows:
1. Insure that the tool operating instructions are being followed before applying another
strap.
2. Cut the strap off and apply another.
A good weld will show some material displacement along
the edges. The welded area should extend the full length
and width of the gripper impression.
If the joint still does not appear as shown, then inspect the tool for worn and/or damaged
parts. Replace tool parts as needed. NEVER HANDLE OR SHIP ANY LOAD WITH
IMPROPERLY FORMED JOINTS. Misformed joints may not secure the load and could cause
serious injury.
15