Signode TENSION-WELD VT-16HD Operation, Parts And Safety Manual page 14

OPERATING INSTRUCTIONS, Continued
5. The internal weld timer is
energized. The main piston
brings the welding pads
together and the strap is
welded.
The supply end of the strap is
then cut off. Pull the cut strap
away from the tool during
welding. The tool will continue
through the weld cycle and stop
automatically.
5. When the weld cycle has completed the weld mechanism slowly returns to the neutral
position. This allows the newly welded strap joint to cool down properly. The tool can be
easily removed once the weld mechanism has completely returned to the neutral position.
NOTE: The weld
mechanism's return to the
neutral position can be
identified by the indicator
located on the top of the
tool. When the indicator is
in the down position the
weld mechanism is still
engaging the strap. When
the indicator is in the up
position the weld
mechanism has returned to
the neutral position. The
tool can then be easily
removed from the strap.
Remove the tool from the strap by first lifting
up the tension release lever found on the
bottom of the gear housing while squeezing
the tension motor and stationary handle
together to open the strap path.
NOTE: Failure to wait for the weld mechanism to return to the neutral position may lead to an
improperly formed joint which may lead to joint separation and make tool removal difficult.
INDICATOR IN THE UP POSITION
(NEUTRAL)
14
INDICATOR IN THE DOWN POSITION
(ENGAGED)