Weller WD 1000T Operating Manual page 29

WD 1 (M) / WD 1000
Unlock the soldering station:
1. Select the menu item LOCK in Menu 1.
"ON" appears in the display. The padlock symbol is displayed.
2. Enter the 3-digit lock code with the UP or DOWN button.
3. Press the III button.
The station is now unlocked. The display switches to the main
menu.
Note The soldering station can also be unlocked using a decoder list or
the reset connector.
7.2 Selecting Menu 2 special functions
Special functions
ID
FCC
AUTO CHANNEL
HI / LO CONTROL
1. Select the desired channel I, II or III for entering the special
functions.
2. Press and hold down the UP and DOWN buttons simultaneously.
"– 2 –" appears in the display after 4 s.
3. Release the buttons.
Selection of the special functions of Menu 2 is activated.
The settings can now be made.
- Press the I and II buttons to select menu items.
- Press the III button to exit the menu again (EXIT).
Setting the station identification (ID code)
When the optional USB port is used, several WD 1 (M) / WD 1000
soldering stations can be activated and remote-controlled to their full
operational extent. To this end, each station requires a station
identification (ID code) so that it can clearly identified.
1. Select the menu item REMOTE ID in Menu 2.
2. Enter an ID with the UP or DOWN button
(possible values 0 – 999).
3. Press the I (back) or II (forwards) button to switch to the next
menu item.
Note Press button III to exit the menu item without changes (EXIT).
Executing the calibration function (Factory Calibration Check)
With the FCC function you can check the temperature precision of
the soldering station and compensate for possible deviations. For
this purpose, the soldering-tip temperature must be measured with
an external temperature meter and a temperature measuring tip
assigned to the soldering tool. The corresponding channel must be
selected prior to calibration.
Navigation
I
II
III
EXIT
13-16