Omron XS5 Manual page 13

Tools
Crimp Tool
XY2F-0002
Use the Crimp Tool to crimp a cable core to the XS5U or XS2U
Crimping Pin used with the XS@C or XS@G Crimping Connector.
• The XY2F-0002 Crimp Tool is DMC's AFM8 (M22520/2-01).
• Mount the XY2F-0003 Locator (sold separately) to the locator
guide of the Crimp Tool with a screw provided with the XY2F-0003
Locator.
Pin-block Extraction Tool
XY2F-0001
Use this tool to extract a Pin Block from the covers in order to make
wiring changes or corrections after the cover has been mounted to the
pin block for Connector Assemblies (XS@C/XS@G, soldering/
crimping).
Extraction Procedure
(1) Disconnecting Components
• Disconnect all components on the cap side from the cover.
Pin block Cover
(2) Extracting Pin Block
• Insert the claws of the Tool into the four holes of the cover.
Locator
XY2F-0003
Rubber Cable Cap
bushing clamp
Holes
Claws
Tool in open position
SEL.
NO.
5
Selector dial
(Set to 6.)
Locator guide
XY2F-0003
Locator
• Make sure that the pin block is outside the Tool.
Tool
Pin block
Guide
Cover
• Press the Tool so that the guides of the Tool are in close contact.
Then pull the pin block straight.
Guide
Precaution for Safe Use
• The pin block must not be extracted from the same Connector
more than 3 times, otherwise the proper degree of protection of the
pin block or Connector will not be maintained.
XS5
Tool in closed
position
XY2F-0002
Crimp Tool
Model
XY2F-0002
XY2F-0003
Model
XY2F-0001
Cover
Pin block
Extracting
direction
13