Error Messages - Yamaha W5 Owner's Manual

ERROR MESSAGES

During operation, the W5/W7 may display a number of error messages when
attempting to perform certain functions. Descriptions of each are explained below.
MEMORY
DISPLAY
Song memory full !
Data Empty !
Song voice memory full !
Song element memory full !
Song voice does not exist !
Voice bank is off !
No data !
DISK
DISPLAY
Disk not ready !
Bad disk !
Write protected !
Media type error !
Illegal file !
File not found !
Disk full !
Illegal disk !
Disk unformatted !
File already exists !
Illegal file name !
MIDI
DISPLAY
MIDI buffer full !
MIDI data error !
MIDI checksum error !
Device number is off !
Device number mismatch !
OTHERS
DISPLAY
Change internal battery !
Illegal data !
Data is corrupted. Fixed !
SMF illegal timebase !
1 5 2
COMMENTS
The sequencer s internal memory is full. Execution of song jobs including recording, bulk
reception, and loading from disks is not possible.
You have attempted to perform a song job on a measure that contains no data.
Since the internal memory is full, a Song voice memory bank cannot be created.
Since the internal memory is full, the elements cannot be loaded.
Since a Song voice bank has not been created for the selected song, voices cannot be selected or
edited from the Song voice bank.
Since the voice bank is set to off (no display at the Voice Category), you cannot enter Voice Edit
Mode.
Since the source Song voice bank does not exist, the Song voice memory operation cannot be
executed.
COMMENTS
The disk is not correctly inserted into the disk drive.
The inserted disk is faulty.
You are trying to write to a disk that has its write-protect tab in place.
The disk is not a 2DD type disk.
The file is not of a type that can be read by the W5/W7.
The file could not be located on the inserted disk.
There is no more memory available on the disk.
The data in the disk is faulty.
The disk has not been formatted.
A file with the same name already exists on the disk.
The file name cannot be recognized by W5/W7.
COMMENTS
When attempting to receive or transmit a large amount of MIDI data, the W5/W7 s handling
capacity was exceeded.
An error occurred while receiving or transmitting MIDI data.
An error occurred while receiving bulk data.
Since the device number is switched off, bulk data cannot be transmitted or received.
Since the device numbers are not matched, the bulk data was not received or transmitted.
COMMENTS
The internal backup battery needs to be replaced.
The entered data is not logical.
Since the data is corrupted, the internal memory has been replaced by the factory-set status.
The tempo data created by another SMF device is not compatible with the W5/W7 s tempo track.