Yamaha W5 Owner's Manual page 125

MODULATION WHEEL - To specify the Modulation
Wheel parameters for each element and Modulation
Wheel settings which affect all elements equally, from
within the Controller parameters function, press [F5]
( MW ).
MODULATION WHEEL (off, on) - Position the
cursor over the MW status field and use the JOG
or INC/DEC to switch the modulation wheel
controller on or off for each element.
EG BIAS (-127 ~ +127) - Position the cursor over
the EG Bias value field and use the JOG, INC/DEC
or the KEYPAD to determine how much the ampli-
tude EG (for all elements equally) is increased or
decreased by the modulation wheel.
CUTOFF (-127 ~ +127) - Position the cursor over
the Cutoff value field and use the JOG, INC/DEC
or the KEYPAD to determine how the cutoff fre-
quencies (for all elements equally) are controlled by
the modulation wheel. Positive settings cause the
cutoff frequencies to increase when the modulation
wheel is at maximum position.
AMPLITUDE MODULATION DEPTH (0 ~ 127)
- Position the cursor over the AMD value field and
use the JOG, INC/DEC or the KEYPAD to determine
how greatly the modulation wheel will affect the
output level (amplitude) of all elements equally.
PITCH MODULATION DEPTH (0 ~ 127) -
Position the cursor over the PMD value field and
use the JOG, INC/DEC or the KEYPAD to determine
how greatly the modulation wheel will affect the
pitch of all elements equally.
FILTER MODULATION DEPTH (0 ~ 127) -
Position the cursor over the FMD value field and
use the JOG, INC/DEC or the KEYPAD to determine
how greatly the modulation wheel will affect the
cutoff frequencies of the filter (for all elements
equally).
FOOT CONTROLLER - To specify the Foot Controller
status for each element and Foot Controller settings
which affect all elements equally, from within the
Controller parameters function, press [F6] ( FC ).
FOOT CONTROLLER (off, on) - Position the
cursor over the FC status field and use the JOG or
INC/DEC to switch the foot controller on or off for
each element, when a foot switch is connected to the
FOOT CONTROLLER jack on the rear panel.
EG BIAS (-127 ~ +127) - Position the cursor over
the EG Bias value field and use the JOG, INC/DEC
or the KEYPAD to determine how much the ampli-
tude EG (for all elements equally) is increased or
decreased by the foot controller.
CUTOFF (-127 ~ +127) - Position the cursor over
the Cutoff value field and use the JOG, INC/DEC
or the KEYPAD to determine how the cutoff fre-
quencies (for all elements equally) are controlled by
the foot controller. Positive settings cause the cutoff
frequencies to increase when the foot controller is at
maximum position.
AMPLITUDE MODULATION DEPTH (0 ~ 127)
- Position the cursor over the AMD value field and
use the JOG, INC/DEC or the KEYPAD to determine
how greatly the foot controller will affect the output
level (amplitude) of all elements equally.
PITCH MODULATION DEPTH (0 ~ 127) -
Position the cursor over the PMD value field and
use the JOG, INC/DEC or the KEYPAD to determine
how greatly the foot controller will affect the pitch of
all elements equally.
FILTER MODULATION DEPTH (0 ~ 127) -
Position the cursor over the FMD value field and
use the JOG, INC/DEC or the KEYPAD to determine
how greatly the foot controller will affect the cutoff
frequencies of the filter (for all elements equally).
1 2 3