Chapter 3 - Installing the Yamaha CDR200tx Drive
Cable Connection
Power cable
Insert the power cable securely to the "AC IN" connector on the rear
panel.
SCSI cable
Connect the SCSI cable to either of the CDR200tx rear panel SCSI
connectors (1) or (2), and connect the other end of the SCSI cable to
the host computer.
The CDR200tx is not supplied with a SCSI cable. You will need to
obtain one that will fit the drive and the host computer connectors.
AC I N
AC I N
CDR ID
TERMINATOR
1
OFF
SCSI-1
SCSI-2
LINE OUT
CDR ID
R
L
TERMINATOR
1
OFF
ON
SCSI-1
SCSI-2
LINE OUT
R
L
ON
To the next SCSI device: host
computer, hard disk drive, etc.
9