Specification - Xantrex XPF 35-10 Operating Manual

OUTPUT SPECIFICATIONS
Voltage Range:
Current Range:
Power Range:
Output Voltage Setting:
Output Current Setting:
Operating Mode:
Output Switch:
Output Terminals:
Sensing:
Output Impedance:
Output Protection:
OVP Range:
Line & Load Regulation:
Ripple & Noise
(20MHz bandwidth):
Transient Load Response:
Temperature Coefficient:
Status Indication:
0V to 35V
0A to 10A
Up to 175W
By coarse and fine controls.
By single logarithmic control.
Constant voltage or constant current with automatic cross-over
provided that the power demanded stays within the power
envelope, see graph. Outside of this envelope the output becomes
unregulated.
Electronic. Preset voltage and current displayed when off.
4mm terminals on 19mm (0·75") pitch. 15A max.
Switchable between local and remote. Spring-loaded push
terminals for remote connection.
Typically <5mΩ in constant voltage mode.
Typically >5kΩ in constant current mode (voltage limit at max).
Forward protection by Over-Voltage Protection (OVP) trip;
maximum voltage that should be applied to the terminals is 50V.
Reverse protection by diode clamp for reverse currents up to 3A.
10% to 110% of maximum output voltage set by front panel
screwdriver adjustment.
<0.01% of maximum output for a 10% line change; <0.05% of
maximum output for a 90% load change.
5mVrms max; typically <2mVrms, <20mV pk-pk, both outputs fully
loaded (7A @ 25V), CV mode.
<2ms to within 100mV of set level for 90% load change.
Typically <100ppm/°C
Output on lamp.
Constant voltage mode lamp.
Constant current mode lamp.
Unregulated (power limit) lamp
Trip message on display.

Specification

3