Table of Contents
Advertisement
Quick Links
MOD-500TDM/AF w/Single Control Panel
IMPORTANT: DO NOT DISCARD THIS MANUAL
This manual is considered to be part of the appliance and is to be given to the OWNER or
MANAGER of the restaurant, or to the person responsible for TRAINING OPERATORS of
this appliance. Additional manuals are available from your WELLS DEALER.
THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR
INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any
questions concerning installation, operation or maintenance of this equipment.
2M-
p/n
308026 Rev. (A)
WELLS BLOOMFIELD, LLC
10 Sunnen Dr., St. Louis, MO 63143
telephone: 314-678-6314
fax: 314-781-2714
www.wells-mfg.com
OWNERS MANUAL
BUILT-IN
FIVE-WELL
MODULAR
AUTO-FILL
WARMERS
MODELS
MOD500TDM/AF
MOD527TDM/AF
Includes
INSTALLATION
USE & CARE
EXPLODED VIEW
PARTS LIST
WIRING DIAGRAM
M011C.15
11
011C
0908
Advertisement
Table of Contents
Related Manuals for Wells MOD500TDM/AF
Summary of Contents for Wells MOD500TDM/AF
- Page 1 Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
-
Page 2: Limited Warranty Statement
LIMITED WARRANTY STATEMENT Unless otherwise specified, all commercial cooking personnel. The prices charged by Wells Bloomfield for its equipment manufactured by WELLS BLOOMFIELD, LLC is products are based upon the limitations in this warranty. warranted against defects in materials and workmanship Seller’s obligation under this warranty is limited to the... - Page 3 PARTS & SERVICE CUSTOMER SERVICE DATA INTRODUCTION Thank You for purchasing this Wells Bloomfield appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.
-
Page 4: Features & Operating Controls
FEATURES & OPERATING CONTROLS A. THERMOSTAT On THERMOSTATICALLY CONTROLLED warmers, power is applied to the heating element according to the control knob position and the actual temperature at the temperature sensing thermobulb. The desired temperature is controlled by rotating the TEMPERATURE CONTROL kNOB. -
Page 5: Precautions And General Information
Do not operate this appliance if the control panel is damaged. Call read and followed. Damage your Authorized Wells Service Agent for service. to the appliance may result The technical content of this manual, including any wiring diagrams,... -
Page 6: Unpacking And Inspection
INSTALLATION NOTE: DO NOT discard UNPACkING & INSPECTION the carton or other packing Carefully remove the appliance from the carton. Remove all protective materials until you have plastic film, packing materials and accessories from the Appliance inspected the appliance for before connecting electrical power or otherwise performing any hidden damage and tested it installation procedure. -
Page 7: Electrical Installation
INSTALLATION For “top-mounted” warmers (i.e. warmers mounted from above the counter top): Verify that provided sealants are applied to the underside of the warmer top flange prior to setting the unit into the cutout. After installation, verify that the tabs on the Wellsloks are turned out to lock the warmer into the counter Apply a thin bead of food-grade silicone sealant around the flange to seal it to the counter. -
Page 8: Operation
OPERATION CAUTION: AUTOFILL WARMERS Autofill warmers sense water level by a sensor placed at the HOT SURFACE proper level. For manifolded autofill warmers, the water level Exposed surfaces can be hot sensor / fill tube is in one pan only, normally in the far left pan. to the touch and may cause Water fills the pan through an inlet tube. -
Page 9: Maintenance Instructions
Never use metal implements, wire brushes, abrasive scratch pads or steel wool to clean stainless steel. Warmer pans, insets and other vessels are subject to a harsher environment. Wells Manufacturing uses an very high quality stainless steel (#304DDQ) for our food warmer pans. -
Page 10: Cleaning Instructions
Contact your Authorized Wells Service Agency to inspect warmer if water or grease contamination is suspected. Close drain valve. Add proper amount of warm water. Turn control... -
Page 11: Weekly Cleaning Instructions
CLEANING INSTRUCTIONS WEEkLY CLEANING INSTRUCTIONS CAUTION: CHEMICAL BURN Remove any insets, pans and/or adapter PREPARATIONS: HAzARD tops. Drain or remove water from well if used Deilimng chemicals may be for wet operation. caustic. Wear appropriate personal protective equipment. FREQUENCY: Weekly, or whenever lime or scale is seen Follow cleaner manufacturer’s accumulating on the sides of the warmer instructions for safest use. -
Page 12: Troubleshooting Suggestions
Verify flange-to counter seal is sound, or reseal with Wet insulation food-grade silicone sealant Warmer trips circuit Pan leaking or other internal Contact your Authorized Wells Service Agency for breaker damage repairs Contact your Authorized Wells Service Agency for Internal damage... -
Page 13: Wiring Diagram
WIRING DIAGRAM... -
Page 14: Exploded View And Parts List
EXPLODED VIEW & PARTS LIST MOD-500TDM A/F (SPLIT CONTROL BOX) 2H-36196 (Sold by the Foot) ELEMENT ONLY KIT PAN 2N-303375UL w/ELEMENT (208/240V) WS-503843 ELEMENT PAN KIT WS-503842 THERMOBULB (ref.) BRKT THERMO BULB D8-303352 INSUL, 36”w (sold by the foot) 2H-36050 P2-307110 2P-21709 PAN ASSY, QTY 4... - Page 15 EXPLODED VIEW & PARTS LIST MOD-500TDM A/F (SINGLE CONTROL BOX) make from 2H-36196 sold by the foot ELEMENT ONLY ELEMENT & PAN 2N-303375UL (208/240V) ASSEMBLY WS-503842 (208/240V) ELEMENT PAN KIT WS-503842 THERMOBULB (ref) D8-3033252 made from 2H-36050 P2-307110 (150’ roll) 5P-21709 PAN ASSY, QTY 4 WS-55742...
- Page 16 WS-500700 500712 2K-48198 PAN ASSY, QTY 1 2K-48197 WS-504101 2V-47650 2V-35609 WS-503713 2K-47662 2K-31040 2C-46591 WS-50131 2C-41974 E7-49046 2K-31040 2J-35687 WS-50131 2T-45917 2C-41974 P2-Z12288 2I-40034 2J-35687 2E-306865 2T-45917 2I-Z12311 2R-40498 P2-40843 2K-34136X 2E-46529 2R-40498 2C-46591 P2-46587 WELLS WELLS IL2328, PL011C...
- Page 17 PAN KIT WS-503841 THERMOBULB (ref.) D8-303352 5P-21709 PAN ASSY, QTY 4 WS-500700 P2-300712 2K-48198 2K-48197 2K-31040 2V-47650 PAN ASSY, QTY 1 WS-504101 2V-35609 2K-47662 WS-503713 WS-50131 2C-46591 2C-41974 2T-45917 2J-35687 2I-40034 2I-Z12311 2E-306865 2K-34136X 2E-46529 2R-40498 2C-45691 P2-46587 WELLS IL2329, PL011C...
-
Page 18: Parts And Service
PARTS & SERVICE Always use an inset. DESCRIPTION PART NO. DO NOT place food directly into the warmer pan. ADAPTERS & INSETS ADAPTER TOP, convert 12” x 20” warmer to hold two 7 qt. insets 5J-21502 ADAPTER TOP, convert 12” x 20” warmer to hold two 4 qt. -
Page 19: Customer Service Data
6 oz. SOUP LADLE 5J-21860 or to order factory authorized replacement parts, contact WELLSLOk EXTENSION kIT, for UL LISTED your Wells authorized service circular warmers only, adapt to wood counter agency, or call: up to 1¾” thick 5P-22592* Wells Bloomfield, LLC WELLSLOk EXTENSION kIT, for UL LISTED 10 Sunnen Dr., P.O.Box 430129... - Page 20 WELLS BLOOMFIELD, LLC 10 Sunnen Dr., St. Louis, MO 63143 telephone: 314-678-6314 fax: 314-781-2714 www.wells-mfg.com...