Turbo Air TB-4 Installation And Operation Manual page 9

OPERATING INSTRUCTIONS
SHELF PLACEMENT :
The shelves can be installed slanted or straight. To make the shelf slanted do the
following.
a. Shelf needs to be removed from shelf support.
b. Shelf support needs to be held at each end.
c. Shelf support needs to be lifted at the back till bracket can be inserted into self
standard slots.
Refer to drawing of page 4.
ADJUSTING SHELF LEVEL
Shelves can be adjusted up or down. To move shelves do the following ;
a. Lights must be turned off.
b. Grasp plug for light cord and unplug.
c. Shelves must be removed from shelf support.
d. Hold onto each end of shelf support.
e. Shelf support needs to be moved up until it can be removed from shelf standard.
REPLACEMENT OF LIGHT
When replacing lights use same model of light installed in Bakery Case. Using wrong
wattage can cause ballast to burn out or light not work.
To remove light there is two lamp holders one at each end of light. One has a spring in
socket. Push light toward spring loaded lamp holder till other end of light pops out of
other lamp holder.
Remove light from lamp shield and insert new light into lamp shield. Reinsert into lamp
holders. Never install lamp without shield.
9