Advertisement
Make sure that the wall is strong enough to withstand at
least 4 times the weight of the device and the mount.
The standard power supply is 12 VDC or PoE, please make
sure your power supply matches with your device.
Make sure that the power has been disconnected before
you wire, install, or disassemble the device.
Make sure that no reflective surface is too close to the
device lens. The IR light from the device may reflect back
into the lens causing reflection.
sticker is to indicate that the marked item can be hot and
should not be touched without taking care. For device with
this sticker, this device is intended for installation in a
restricted access location, access can only be gained by
service persons or by users who have been instructed
about the reasons for the restrictions applied to the location
and about any precautions that shall be taken.
Symbols and Marks
CAUTION: Hot parts! Burned fingers when
handling the parts. Wait one-half hour after
switching off before handling parts. This
Notice
Warning
Forbidden
Correct
Incorrect
Turn to page A and continue.
Advertisement
