Advertisement
The foam ring around the lens must be seated flush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring and
the dome cover are attached seamlessly.
Emergency
If smoke, odor, or noise arises from the device, immediately turn off
the power, unplug the power cable, and contact the service center.
Time Synchronization
Set up camera time manually for the first time access if the local
time is not synchronized with that of the network. Visit the camera
via Web browse/client software and go to time settings interface.
Installation
Make sure the device is firmly secured to any wall or ceiling
mountings.
Be sure that there is enough space to install the camera and
accessories.
Make sure that the device in the package is in good condition and
all the assembly parts are included.
Make sure that the wall is strong enough to withstand at least 4
times the weight of the camera and the mount.
Make sure that the power has been disconnected before you wire,
install, or disassemble the device.
Make sure that no reflective surface is too close to the camera lens.
The IR light from the camera may reflect back into the lens causing
reflection.
and should not be touched without taking care. For device with this
sticker, this device is intended for installation in a restricted access
location, access can only be gained by service persons or by users
who have been instructed about the reasons for the restrictions
applied to the location and about any precautions that shall be
taken.
Symbols and Marks
CAUTION: Hot parts! Burned fingers when
handling the parts. Wait one-half hour after
switching off before handling parts. This sticker
is to indicate that the marked item can be hot
Advertisement
