Sharp HR480F Operation Manual page 70

HDD Playback
68
GB
HR480F_GB-065-068
All manuals and user guides at all-guides.com
Switching Audio
You can change the audio output channel
during HDD playback.
Each time AUDIO (under the cover) is
pressed, the audio channels change.
• The way audio channels change differs
depending on the sound recorded on HDD.
See the table on page 109 for details.
NOTE
• When you play a programme recorded in
stereo or monaural, and if you are listening
to the BIT STREAM sound via the digital
output jack, you cannot select the audio
channel. Set "DGTL AUDIO OUT SET" to
"PCM" (see page 112), or if you want to
change the audio channel, listen via the
analogue output jacks.
Repeat Playback of a Title
or Chapter (Repeat Play-
back)
1
Play back the title or chapter you
want to repeat.
2
Press (INPUT).
3
Press \ / | to select the type of
Repeat Playback.
• PLAYING BACK TITLE: Repeats the
title currently playing back.
• PLAYING BACK CHAP: Repeats the
chapter currently playing back.
• SPECIFY THE PART: Repeats the
specified scene of title or chapter.
SELECT REPEAT PLAYBACK TYPE.
PLAYING BACK TITLE PLAYING BACK CHAP
\ | SELECT
ENTER
• Press RETURN to cancel without
setting the type of Repeat Playback.
68
4
Press SET/ENTER.
Example: Repeat playback of a title
(TITLE)
5
Press
normal playback.
Partial Repeat Playback
(Repeat Playback of a
Specified Part)
1
Press
playback.
2
Press \ / | to select "SPECIFY
THE PART", then press SET/
ENTER.
3
Press SET/ENTER when you
reach the scene you want to start
Repeat Playback.
• The start point of the part (A) will be
memorized.
PLAYING BACK TITLE
4
Press SET/ENTER when you
reach the scene you want to end
Repeat Playback.
• The end point of the part (B) will be
memorized and the Repeat Playback
for the specified part (A-B) starts.
5
Press
SPECIFY THE PART
normal playback.
NOTE
• For Partial Repeat Playback, set the start
and end points within the same title.
05.3.23, 1:59 PM
TITLE REPEAT
(INPUT) to return to
(INPUT) during
SELECT REPEAT PLAYBACK TYPE.
PLAYING BACK CHAP SPECIFY THE PART
SET START POINT
(INPUT) to return to