Closed Caption; Lamp Power; Remote Control; Security - Panasonic PT-VW431DEA Operating Instructions Manual

Count up

"000:00"
Count down Timer that you set
Note
To stop the P-timer function, press the <P-TIMER>
z
button.
To cancel the [P-timer], press and hold the <P-TIMER>
z
button for a few seconds.

Closed caption

[Only for NTSC, 480i input]
1 ) Press ▲▼ to select [Closed caption].
2 ) Press ► or the <ENTER> button to
enter the submenu.

Closed caption

J
1 ) Press ▲▼ to select [Closed caption]
and then press the <ENTER> button.
2 ) Press ▲▼ to select [Off], [CC1], [CC2],
[CC3] or [CC4].
Color
J
1 ) Press ▲▼ to select [Color] and then
press the <ENTER> button.
2 ) Press▲▼ to select [color] or [white].
Attention
The closed caption is mainly used in the north America.
z
This function shows the text information contained in the
image signal. Captions may not be displayed on some
devices or software.
You can select [Closed caption] when matching signals
z
for the closed caption are input.
Part of characters may not displayed when high
z
compensation values are set in [Keystone].
Closed captions will not be displayed while the menu
z
screen, P-timer or other items appear.

Lamp power

This function allows you to change brightness of the
screen.
1 ) Press ▲▼ to select [Lamp power] and
then press the <ENTER> button .
2 ) Press ▲▼ to select one among the
modes as below.
You can also press the <LAMP> button to
z
display [Lamp power].
Normal Normal brightness.
Lower brightness reduces the
Eco lamp power consumption and
extends the lamp life.
Note
If [Lamp power] is set to [Normal] and the operating
z
environment temperature exceeds 35 °C (95 °F), [Lamp
power] may be changed to [Eco] automatically.

Remote control

This switching function prevents remote control
interference when operating several projectors or
video equipment at the same time.
1 ) Press ▲▼ to select [Remote control].
2 ) Press ► or the <ENTER> button.
3 ) Press ▲▼ to select one among the
seven codes.
This projector provides 7 different remote
z
control codes: [ALL], [Code 1]~[Code 6].
Attention
When operating the projector under [ALL] code, you can
z
operate several projectors at the same time. If you want
to operate the projector independently, you must switch
to other code.
When different codes are set on the projector and on the
z
remote control, any operation cannot be made. In that
case, switch the code on the remote control to fit the
code on the projector.
If the batteries are removed from the remote control for a
z
long period of time, the remote control code will be reset.

Security

This function allows you to use the Key lock and PIN
code lock function to set the security for the projector
operation.
1 ) Press ▲▼ to select [Security].
2 ) Press ► or the <ENTER> button to
access the submenu.
Key lock
J
This function locks the control panel and remote
control buttons to prevent operation by unauthorized
persons.
Setting
55
ENGLISH -