Technibel Climatisation CAFM 74 R Instruction Manual page 37

How to remove the filter
(continued)
Wall-mounted type (MAFM):
Floor standing type
(KFM, KFMNC):
Outdoor unit
CAUTION
Care: after a prolonged
idle period
Care: before a prolonged
idle period
OI-729-37-EG
Care and Cleaning (continued)
1. Move the flap on the air outlet grille to its lowest position with the remote
control unit.
2. The filter is disengaged by pushing the tab up gently. Hold the air filter by
the tab at the bottom, and pull downward.
Air intake grille
When replacing the filter, make sure that the FRONT mark is facing you.
Push it up until you hear it click back into position.
1. Remove the screw at the bottom left of the front panel using a Phillips
head screwdriver. (Be sure to replace the screw when cleaning is
finished.)
2. Remove the filter by pulling it toward you.
Air filter
Screw
1. Certain metal edges and the condenser fins are sharp and may cause
injury if handled improperly; special care should be taken when you
clean these parts.
2. Periodically check the outdoor unit to see if the air outlet or air intake
is clogged with dirt or soot.
3. The internal coil and other components of the outdoor unit must also
be cleaned periodically. Consult your dealer or service center.
Check the indoor and outdoor unit air intakes and outlets for blockage; if there
is a blockage, remove it.
• Operate the fan for half a day to dry out the inside.
• Disconnect the power supply and also turn off the circuit breaker.
• Clean the air filter and replace it in its original position.
• Outdoor unit internal components must be checked and cleaned
periodically. Contact your local dealer for this service.
Air filter
Screw
Air filter
37