The system can alternatively be set to: (must be configured by the installer)
•
Warning Mode (no chirp during lock/unlock – unless one of the doors, the hood or the
trunk is open. In this case there will be 3 chirp when
alarm was triggered, in which case there will be 4 chirps when
•
Open Zone Notification (the system will warn for doors opened up to 10 seconds after
arming).
•
No Chirp (the vehicle will not chirp under any circumstance).
Arming
Arming of the system can be program by your installer into 4 different options. By default, your
system is programmed to "passive arming – 2 stage disarm":
•
Active arming: The system will only arm if
•
Passive arming (2 stage disarm): The system will automatically arm itself 30 seconds
after all doors, hood and trunk are closed.
Note: If an alarm is triggered, pressing the
the doors locked and the system armed.
•
Passive arming (1 stage disarm): The system will automatically arm itself 30 seconds
after all doors, hood and trunk are closed
Note: If an alarm is triggered, pressing the
doors.
•
Active arming with disarm notification: This feature will notify the user when the
vehicle is left disarmed after Ignition is turned off, or when the Module is disarmed after
being previously armed, the opening or closing of a Door will cause the Horn or the
Siren to sound once after 10 sec. to warn the user that the vehicle was left
unprotected. Pressing
Shock Sense & Warn Away sense
If somebody hits, jostles or otherwise moves your car, the shock sensor sends a signal to the brain
indicating the intensity of the motion. Depending on the severity of the shock, the system can react
to a full shock by triggering the alarm or it can also respond to a lighter shock (30 % of the strength
of a full shock) by giving a warn-away (without triggering an Alarm condition). However, when the
Engine is running after a remote start, the full shock is disabled but will still give a warning sound if
warn-away is enabled.
Note: Refer to your installer if you wish to disable the shock sensor permanently.
Siren/Horn Chirp Timing
The pulse duration can be configured by your installer (from 5 ms. to 200 ms.).
Priority door:
If configured by your installer, this great feature allows you to unlock solely the driver's door with a
single press of the
pressing the
button for a second time.
User Guide
or
will cancel this timer.
button on the transmitter, and to unlock the other doors, if desired, by
is pressed. – Or unless the
is pressed.
button is pressed
button will stop the siren while keeping
button will stop the siren and unlock the
P. 19