Temperature Request (Ifacc-Temp -101 Installed ); Temporary Chirp Delete; Relock; Remote Finder - Directed Electronics AS-6870TW-FM User Manual

Temperature Request (If ACC­Temp­101 installed)
The user can request the temperature in the vehicle if a Temperature Sensor Module (ACC-Temp-
101) is installed:
•
Through advance function remote's menu (page-6), select L-01.
•
Immediately press the
LCD screen.
Temporary Chirp Delete
To temporarily disable the chirp confirmations of the siren upon arming and disarming (e.g. in a
quiet neighbourhood):
• Press the
• Immediately, press the
Relock
If you unlock the doors with the remote transmitter, but do not open any door, hood, trunk or turn
ignition within 30 seconds, the system will automatically relock and arm.
ON
Note: When the system is in active arming mode and the relock mode is enabled, the doors
will relock but the system will not rearm.
Remote finder
This function will help you locate your remote. The unit will send a signal to the remote to trigger
the remote to beep informing you of its location. Follow this procedure to activate remote finder.
1. Locate the push button switch in the car. (refer to your installer for its location)
2. Press and hold the push button switch until the parking lights flash 5 times.
Press the or
Missing a Start or a Stop Confirmation
If you have not received a Start or the Stop confirmation after pressing the button, pressing the
button will refresh the display and will confirm if the vehicle was started or stopped.
If no Start Confirmation Was Received:
•
Press the
If no Stop Confirmation Was Received:
•
Press the
P. 16
button and hold it until the temperature is displayed on the
button. The remote will beep once.
or
button to stop the beeping of the remote once it is found.
button:
The remote's
icon
The icon and runtime time countdown will be displayed.
button:
The will be displayed
The remote's icon and the runtime countdown will disappear.
button to arm or disarm system without any chirp.
will start flashing
User Guide