Summit REX205W Owner's Manual And Installation Instructions page 43

Before you call for service...
Problem
Oven temperature too
hot or too cold
Clock and timer do
not work
Display goes blank
Oven door is crooked
Oven makes clicking
noise
"F-and number or let-
ter" flash in the display
Power outage
Display flashes
Unable to get the dis-
play to show "SF"
Possible Causes
Oven thermostat needs adjust-
ment.
Plug on range is not completely
inserted in the electrical outlet.
A fuse in your home may be
blown or the circuit breaker
tripped.
Oven controls improperly set.
A fuse in your home may be
blown or the circuit breaker
tripped.
The clock is turned off from show-
ing in the display.
The door is out of position.
This is the sound of the heating
element turning off and on dur-
ing cooking functions.
You have a function error code.
If the function code repeats:
Power outage or surge.
Power failure.
Oven control pads were not
pressed properly.
What To Do
• See the Adjust the oven thermostat-Easy to do your-
self! Section.
• Make sure electrical plug is plugged into a live, prop-
erly grounded outlet.
• Replace fuse or reset circuit breaker.
• See the Using the clock, timer and convenience outlet
section.
• Replace fuse or reset circuit breaker.
• See the Using the clock, timer and convenience outlet
section.
• Because the oven door is removable, it sometimes
gets out of position during installation. To straighten the
door, push down on the high corner.
• This is normal.
• Press the OFF pad. Put the oven back into operation.
• Disconnect all power to the range for at least 30 sec-
onds and then reconnect power. If the function error
code repeats, call for service.
• On self-cleaning models, if a function error code ap-
pears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Make sure the latch is
moved to the right as far as it will go. Press the OFF
pad. Allow the oven to cool for one hour. Put the oven
back into operation.
• Some models will automatically resume their setting
once the power is restored. On models with a clock,
you must reset the clock. If the oven was in use, you
must reset it by pressing the OFF pad, setting the clock
and resetting any cooking function.
• Reset the clock.
• The BAKE and BROIL pads must be pressed at the
same time and held for 3 seconds.
43