Summit REX205W Owner's Manual And Installation Instructions page 35

ELECTRICAL CONNECTIONS (CONT.)
3 POWER CORD AND STRAIN RELIEF
INSTALLATION
A
Remove the wire cover (on the back of the range) by
removing two (2) screws using a Phillips screw driver.
Do not discard these screws.
2 screws
to remove
wire cover
Back of Range
B
Remove the knockout ring (1 1/8" or 1 3/8" depending
on your model) located on bracket directly below
the terminal block. To remove the knockout, use a
pair of pliers to bend the knock-out ring away from
the bracket and twist until ring is removed.
Knockout ring
in bracket
Installation Instructions
Wire cover
Terminal block
(appearance
may vary)
Knockout ring
removed
C
For power cord installations only (see the next step if
using conduit), assemble the strain relief in the hole.
Insert the power cord through the strain relief and
tighten. Allow enough slack to easily attach the cord
terminals to the terminal block. If tabs are present at
the end of the winged strain relief, they can be re-
moved for better fit.
NOTE: Do not install the power cord without a strain re-
lief. The strain relief bracket should be installed before
reinstalling the rear range wiring cover.
Strain relief
Power cord
Skip to Step 4 or 5.
D
For conduit installations only, purchase a squeeze
connector matching the diameter of your conduit
and assemble it in the hole. Insert the conduit through
the squeeze connector and tighten. Allow enough
slack to easily attach the wires to the terminal block.
NOTE: Do not install the conduit without a squeeze
connector. The squeeze connector should be in-
stalled before reinstalling the rear range wiring cover.
Squeeze
connector
Conduit
Skip to Step 6 or 7.
Terminal
block
Bracket
Terminal
block
Bracket
35