Advertisement
KB100-ST
KB110-SSRE
Installation Instructions
&
Step 1.
Remove changing station from the shipping
container and check for any freight damage.
Identify the best location for installing the unit.
Hold the unit in place and open the bed. Make
sure you have taken the operating clearance
into consideration.
Step 2.
Select the wall area where the unit will be
installed. Measure from the floor 46½" (1181
mm) on stud center and mark the wall. Hold the
unit in place to verify the alignment. Mark rough
opening 35½" W x 20½" H (902 mm x 521 mm)
and cut a hole in the wall with a minimum depth
of 4¼" (108 mm) as measured from the finished
surface of the wall (ie: tile, drywall, etc). Construct
mounting frame as indicated in the illustration.
If the wall surface is masonry or tile over wood
studs, use caution when cutting rough opening.
Step 3.
Mount the unit using four ¼" x 3" wood screws
through side holes as shown in illustration.
Step 4.
Place the unit into the recessed area and use the side mounting holes as a guide to drill a pilot hole
using a 1/8" drill bit. Insert the screws and flat washers through the side mounting holes to hold the
unit in place. It may be necessary to adjust the level of unit by using a shim on the top right or left side
of the unit before tightening securely to the studs.
Step 5.
Position Koala sign (supplied) on the outside of the restroom door. Fill the built-in dispenser with
sanitary bed liners. Replacement parts and additional liners can be purchased from your local
distributor or by calling toll free 888.733.3456 or 303.539.8300 in the U.S.
Advertisement
